Which Bag Is a Sac 32?
A 32 cm Hermès bag matches the Kelly 32. The Kelly 32 measures about 32 cm wide, 23 cm tall, and 12 cm deep. The Birkin line skips 32. Its closest size is the Birkin 30 at about 30 x 22 x 16 cm. Any accessory sold for a Kelly 32 fits a replica labeled "sac 32," with one condition: the replica has to match those numbers.
It often does not. Two workshops can build the same 32 cm shell with base widths that differ by 1 cm to 2 cm. Hardware size shifts too. Measure your own bag before you buy an insert, a base shaper, or a strap.
Four Measurements to Take First
- Interior width at the base, corner to corner.
- Interior depth, front panel to back panel.
- Interior height, base seam to the top edge.
- Handle drop, top of the handle arc to the top edge of the bag.
Use a soft tape and keep the bag empty. A filled bag reads 1 cm to 2 cm wider at the base. Note the interior width in millimeters, because insert makers size in millimeters: 240 mm, 260 mm, 270 mm.
Hermès Sac 32 Replica Bags: What the Size Really Means
Bag Insert and Organizer
An insert for a Kelly 32 runs about 26 cm wide, 12 cm deep, and 14 cm tall. Felt and nylon versions weigh 180 g to 320 g. A stiff insert holds the shape of the base. A soft insert adds pockets for a phone, keys, and cards. Check the insert height against your interior height: if the insert sits 1 cm above the top edge, the flap will not close flat.
Base Shaper
A base shaper is a flat panel, 1 mm to 3 mm thick, cut to the footprint of the interior base. For a Kelly 32 the footprint is about 30 cm by 10 cm. Acrylic and leather board are the two common materials. Acrylic adds about 90 g.
Twilly and Handle Wrap
A twilly is a narrow silk band, 86 cm long and 5 cm wide. One twilly wraps a single handle of a 32 cm bag two times and ties at the base of the handle. Two twillies cover both handles. Silk twill holds a knot. Polyester ribbon slips.
Shoulder Strap
A Kelly 32 strap measures about 105 cm end to end. Look at the D-ring inner width on your bag. Most fall between 14 mm and 20 mm. A strap with 16 mm hardware fits a 14 mm ring with slack and will not fit a 20 mm ring. Measure the ring, not the strap.
Hardware and Small Parts
Replica hardware varies by batch. The turnlock plate on a 32 cm replica runs 30 mm to 34 mm across. Replacement feet, screw posts, and protective caps come in 8 mm, 10 mm, and 12 mm diameters. Buy one spare set of each size you need. Sellers list these parts by diameter, not by bag model.
Rain Cover and Dust Bag
A rain cover for a 32 cm bag measures about 40 cm by 30 cm when flat. A dust bag for the same size runs 40 cm by 30 cm to 45 cm by 35 cm. Cotton flannel is the common fabric. A dust bag that is too small pulls on the handles and leaves a crease in the leather.
Colors and Finishes
Gold-tone and palladium-tone are the two hardware finishes on 32 cm bags. Strap leather comes in Togo, Epsom, and Swift grain. Grain mismatch between the strap and the bag body shows in daylight at 1 m. Pick the strap after you have the bag in hand.
What Fails Most
Three problems come up in order of frequency. Inserts sized for a Birkin 30 sit 4 cm short in a 32 cm shell and slide. Straps with 20 mm hardware do not pass through 14 mm D-rings. Base shapers cut for a 30 cm footprint leave a 1 cm gap at each end. Measure, then order.